Arduino project · Sound and music · Easy
Sound Level Ring
The ring lights up fully when the sound sensor hears a loud sound.
What you will learn
- How a sound module signals loud sounds
- How a ring shows an alarm
- Why an analog microphone would give a smoother meter
How it works
The sound module gives a digital pulse above its set level. The ring goes from 1 pixel (quiet) to all 8 (loud).
Try this next
- Use an analog sound sensor for several levels.
- Add a buzzer for very loud sounds.
- Change the colour with a button.
The simulator program and explanation on this page are original. The idea follows a classic Arduino project that students have built for years.
Parts: sensors and actuators (tap to show or hide)
Try the inputs (virtual sensors)
Pins (you can change them)
| Part | Arduino pin (change it here) | How to wire it |
|---|
Every wire, one by one
Red rail = 5 V from the Arduino 5V pin. Black rail = GND. The coloured wires carry signals. Match the wire colours on the drawing to this list.
| # | Colour | From (part and leg) | To |
|---|
Steps run from top to bottom, then start again. While the simulation runs, the active step is highlighted in green.
Quantities come from the parts you added. The store links open a search for that item on Robu.in, Amazon.in and ThinkRobotics, so you always see what is in stock today. Check the model, voltage and price before you order.
| # | Item | Qty | Search term | Buy / compare |
|---|
The PDF has the circuit sketch, pin table, every wire, sequence, full code, the parts list with store links, do’s and don’ts for each part, and the safety notes. The project file lets you come back and keep editing.
In the real world
A glowing ring of lights
The ring lights as many pixels as your program asks for, from green to red.
Tip: use the gold tab at the bottom of the circuit drawing to pull the real-world view up over the Arduino board. Your parts stay visible above it, so you can press a button and watch the real scene react.
- NeoPixel ring = the glowing ring